Instruction manual
10
www.ultrachefgrills.com
WARNING! Hose: Check for abrasions, melng, cuts, and cracks in the hose. If any of these condions
exist, do not use the gas grill. Have the part replaced by your Ultra Chef Gas Grill dealer or qualied gas
installer.
WARNING! When reinstalling the burner aer cleaning it is very important
that the valve/orice enters the burner tube before lighng your gas grill. If the
valve is not inside the burner tube a re or explosion could occur.
Aluminum Casngs: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white spots
on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding areas from over-
spray.
Follow the manufacture’s direcons for curing.
Cleaning: Use a exible venturi tube brush to clean the inside of the burner. Shake any loose debris from the
burner through the gas inlet. Check the burner ports and valve orices for blockages. Burner ports can close
over me due to cooking debris and corrosion, use an opened paperclip or the supplied port maintenance bit
to clean them. Drill out blocked ports using this drill bit in a small cordless drill. The ports are easier to clean
if the burner is removed from the grill, but it can also be done with the burner installed. Do not ex the drill
bit when drilling the ports, as this will cause the drill bit to break. This drill is for burner ports only, not for the
brass orices (jets) which regulate the ow into the burner. Take care not to enlarge the holes. Ensure the
insect screen is clean, ght, and free of any lint or other debris.
Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing. Replace sear plate mount and ghten screws to complete reinstallaon.