Operating instructions

Close the valve of the gas cylinder or the regulator after use.

Use of this appliance in enclosed areas can be dangerous and is PROHIBITED.

INSTRUCTIONS FOR USE

Please follow these instructions carefully. Failure to do so could result in serious damage to

your barbecue as well as injury to you and your property.

1. Assemble the barbecue following the assembly instructions carefully.

2. Connect the gas hose to the barbecue. Connect the regulator to the hose.

3. Connect the regulator to the cylinder valve following the regulator instructions supplied

with the regulator.

4. Turn all of the control knobs to the “OFF” position before turning on the gas supply to the

appliance.

5. Operate the regulator in accordance with the instructions supplied with the regulator.

LIGHTING YOUR BARBECUE

Lighting Instructions: main burners

1. Turn the control knobs clockwise to the “OFF” position.

2. Connect the regulator to the gas bottle. Turn the gas supply “ON” at the cylinder. Use

soapy water to check for gas leakage between the bottle and the regulator.

3. Push down the right-hand control knob. Keep pressing while turning anti-clockwise to the

“full rate” position and press the ignition button located at the right-hand corner for 5

seconds. This will light the right-hand burner. If not, please repeat this process.

4. If the burner has not ignited, wait 5 minutes before repeating step 3.

5. When the right-hand burner has lit, push down the middle right control knob. Keep

pressing while turning anti-clockwise to the “full rate” position and press the ignition button

located at the right-hand corner for 5 seconds. This will light the middle right burner. If not,

please repeat this process.

6. If the burner does not stay lit, repeat step 5. If the burner has not ignited, wait 5 minutes

and repeat step 5.

7. When the middle right burner has lit, push down the middle left control knob. Keep

pressing while turning anti-clockwise to the “full rate” position and press the ignition button

located at the right-hand corner for 5 seconds. This will light the middle left burner. If not,

please repeat this process.

8. If the burner does not stay lit, repeat step 7. If the burner has not ignited, wait 5 minutes

and repeat step 7.

9. When the middle left burner has lit, push down the left control knob. Keep pressing while

turning anti-clockwise to the “full rate” position and press the ignition button located at the

right-hand corner for 5 seconds. This will light the left burner. If not, please repeat this

process.

10. If the burner does not stay lit, repeat step 9. If the burner has not ignited, wait 5 minutes

and repeat step 9.

11. Adjust the heat by turning the knob to the High/Low (large or small flame symbol on the

control panel) position.