Instruction manual
4
www.ultrachefgrills.com
This Gas Barbecue Is Cered Under Canadian And American Naonal Standards, CAN/CGA-1.6b-2002 and
ANSI Z21.58b-2002 respecvely for Outdoor Gas Grills and should be installed to conform with local codes. In
absence of local codes, install to the current CAN/CSA-B149.1 Propane Installaon Code in Canada or to the
Naonal Fuel Gas Code, ANSIZ223.1/NFPA 54 in the United States.
If a rosserie motor is used, it must be electrically grounded in accordance with local codes or, in absence of
local codes, with the current CSA C22.1Canadian Electrical Code in Canada or the Naonal Electrical Code,
ANSI/NFPA 70 in the United States.
: The burning of gas fuel creates by-products, some of which are on the list as
substances known by the State of California to cause cancer or reproducve harm. When cooking with gas,
always ensure adequate venlaon to the unit, to minimize exposure to such substances.
Propane Cylinder Specicaons
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use a
cylinder with a damaged valve. Use only a propane supply cylinder constructed and marked in accordance
with the specicaons for LP-gas cylinders of the Naonal Standard of Canada, CAN/CSA-b339, Cylinders,
Spheres and Tubes for Transportaon of Dangerous Goods; and Commission, as applicable or the Specica-
ons for LP-Gas Cylinders of the U.S. Department of Transportaon (D.O.T.). This appliance has been de-
signed for use with a 20 lb. (9.1 kg) size propane cylinder only (not supplied).
The propane cylinder must be provided with a cylinder connecon device compable with the connecon
for outdoor cooking appliances. The propane cylinder must be provided with a shut-o valve terminang in
a propane cylinder valve type QCC1, and a safety relief device having direct communicaon with the vapor
space of the cylinder. The cylinder supply system must be arranged for vapor withdrawal and the cylinder
shall include a collar to protect the cylinder valve. The cylinder shall incorporate a listed OPD (overll protec-
on device). Do not store a spare LP-gas cylinder under or near this appliance. Never ll the cylinder beyond
80 percent full.
Use only the pressure regulator and hose assembly provided with this barbecue. Replacement pressure regu-
lators and hose assemblies must be specied by the manufacturer. Do not store a spare propane cylinder on
the shelf beneath the barbecue.
The regulator supplies a pressure of 11 inches. water column to the gas grill and has a QCC1 type ng. Cyl-
inders to be used with this unit must be supplied with a QCC1 cylinder valve. A QCC1 cylinder has a posive
seang connecon, which will not allow gas ow unl a posive seal has been achieved. It is also equipped
with an excess ow device. In order to aain full ow to the grill, the valves must be in the o posion when
the cylinder valve is turned on.
Gas Hook-Up Instrucons
: Ensure that the gas regulator hose is kink free. Remove the cap or plug from the cylinder
fuel valve. Insert the black QCC1 regulator nipple onto the QCC1 fuel valve. Hand ghten clockwise. Do not use
tools. Leak test all joints prior to using the barbecue. A leak test must be performed annually, and each me a
cylinder is hooked up, or if a part of the gas system is replaced.
If this grill is to be connected directly to a house propane gas supply line, follow the instrucons for the natural
gas hook up. Oponal side burners must also follow the natural gas hook up instrucons. Note: The propane
tank heat shield is not required when the grill is connected to a xed fuel supply, as its sole funcon is to shield
the propane tank normally used with the grill. Ensure that the supply pressure being supplied to the unit is
11” water column.
: Set cylinder into the groove of the lower tank mounng bracket. Ensure that
tank valve faces away from the barbecue. Lower the top tank mounng bracket onto the cylinder and ghten
with wing nut.