Instruction manual

10
www.ultrachefgrills.com







: Clean casngs periodically with warm soapy water. Aluminum will not rust, but high
temperatures and weathering can cause oxidaon to occur on aluminum surfaces. This appears as white spots
on the casngs. To renish these areas, clean rst and sand lightly with ne sandpaper. Wipe the surface to
remove any residue and paint with high temperature barbecue paint. Protect surrounding areas from over-
spray. Follow the manufacture’s direcons for curing.

  
Low heat / Low ame when valve
turned to high.
For propane - improper lighng
procedure.
For natural gas - undersized supply
line.
For both gases - improper
preheang.
Ensure lighng procedure is followed carefully. All gas grill
valves must be in the o posion when the tank valve is turned
on. Turn tank on slowly to allow pressure to equalize. See
lighng instrucons.
Pipe must be sized according to installaon code.
Preheat grill with both main burners on high for 10 to 15
minutes.
Excessive are-ups/uneven heat. Sear plates installed incorrectly.
Improper preheang.
Excessive grease and ash build on
sear plates and in drip pan.
Ensure sear plates are installed with the holes towards the
front and the slots on the boom. See assembly instrucons.
Preheat grill with both main burners on high for 10 to 15
minutes.
Clean sear plates and drip pan regularly. Do not line pan with
aluminum foil. Refer to cleaning instrucons.
Burners burn with yellow ame,
accompanied by the smell of gas.
Possible spider web or other
debris, or improper air shuer
adjustment.
Thoroughly clean burner by removing. See general
maintenance instrucons. Open air shuer slightly according to
combuson air adjustment instrucons. (This must be done by
a qualied gas installer.)
Flames li away from burner,
accompanied by the smell of
gas, and possibly dicules in
lighng.
Improper air shuer adjustment. Close air shuer slightly according to combuson air
adjustment instrucons. (This must be done by a qualied gas
installer.)
Burner will not light with the
igniter, but will light with a
match.
Dead baery / or installed
incorrectly.
Loose electrode wire or switch
terminal wires.
Wrong replacement igniter.
Improper gap at electrode p.
Liing ames on burner.
Replace with heavy duty baery.
Check that electrode wire is rmly pushed onto the terminal
on the back of the igniter. Check that the lead wires from the
module to the ignion switch (if equipped) are rmly pushed
onto their respecve terminals.
One spark systems must use a one spark igniter.
Ensure that the collector box is ght and the gap between the
electrode end and the collector box is between 1/8” - 3/16”
(3mm-5mm). The gap can be adjusted by bending the box in
or out.
Close air shuer slightly - see previous problem.