User`s manual

DS-7200/DS-7300/DS-8100 Series DVR USER’S MANUAL
33
Figure 24. Advanced Schedule Configuration Menu
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be configured
with the same settings, select All Cameras from the list.
3. Check the Enable checkbox to enable the recording schedule. If the checkbox is unchecked, the recording
schedule will be disabled.
4. Select a day between Monday to Sunday to configure schedule for.
5. Setup time periods for schedule. If the 24HR checkbox is checked, recording will occur over the entire day.
To setup multiple time periods, uncheck 24HRand enter the Start and Stop Time for the selected day. The start
and stop time are listed using a 24 hr cycle (i.e. 18:00 is equivalent to 6:00pm).
6. Select recording type under Type for selected day of the week. Recording type includes Continuous for
continuous recording or On Event for recording when an event is triggered (i.e. from detected motion) for the
selected time period.
7. If there are scheduling errors detected, such as overlapping time periods, error messages such as those
shown in Figure 25 will appear.
Figure 25. Advanced Schedule Configuration Error Messages
8. Check the Enable Audio checkbox if you would like to enable audio recording along with the video. Audio
can only be recorded if an audio source (such as a microphone) is connected to the DVR.
9. Select the Add button to add time frame to schedule. The newly added time frame will appear in the
schedule on the left, with the schedule parameters shown on the right. Continuous recordings are shown in blue
on the schedule while event recordings are shown in yellow. An example of this can be seen in Figure 26.
Figure 26. Advanced Schedule Configuration Example