Specifications

Quick Operation Guide of DS-7200-SH/SV Series DVR

1. Disconnect pluggable block from the ALARM IN /ALARM OUT terminal block.

2. Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange part.

Ensure signal cables are in tight.

3. Connect pluggable block back into terminal block.

RS-485 Connections

To connect RS-485 devices (e.g., pan/tilt unit) to the DVR:

Press and hold the orange part of the pluggable block; insert signal cables into slots and release the orange part.

Ensure signal cables are in tight.

Note: Make sure the pan/tilt receiver unit is connected to the D+ and D- of the RS-485 terminal of DVR.