Specifications

Quick Operation Guide of DS-7200-SH/SV Series DVR
Table 7 Mouse Operation in Live View
Icon Name Description
Main Menu Enter the main menu of the system.
Single Screen Switch to the single full screen live view mode.
Multi-screen Switch to multi-screen live view mode.
Note: The multi-screen icon varies according to the device models.
Normal Record Start all-day normal recording for all channels.
Motion Detection
Record
Start motion detection recording for all channels.
Playback Play back the record video.
Aux Monitor Switch to the auxiliary output mode and the operation for the main output is
disabled.
Note: If you enter Aux monitor mode and the Aux monitor is not connected,
the mouse operation is disabled; you need to switch back to the Main output
with the VOIP/MON button and Enter button on IR remote control.
Output Mode Set the video output mode to Standard, Bright, Gentle or Vivid.
Quick NetSet Quick settings of the network parameters, e.g., DDNS, UPnP™ and DHCP.
Previous Screen Switch to the previous screen.
Next Screen Switch to the next screen.
Start/Stop Auto-
switch
Enable/disable the auto-switch of the screens.
Note: The dwell time of the live view configuration must be set before using
Start Auto-switch.
Main/Aux Output Switching
When the HDMI/VGA output is configured as the main output, you can perform the following operation to switch
to CVBS output as the main output.
Steps:
1. Use the mouse wheel to double-click on the HDMI/VGA output screen, and the following message box pops
up:
2. Use the mouse wheel to double-click on the screen again to switch to the Aux output, or click Cancel to
cancel the operation.
PTZ Control
Follow the procedure to set the parameters for PTZ. The configuring of the PTZ parameters should be done before
you set the PTZ camera.
Before you start, please check that the PTZ and the DVR are connected properly through RS-485 interface.
In the Live View mode, you can press the PTZ Control button on the IR remote control, or choose the PTZ
21