User's Manual

32
STEP 1
STEP 1
STEP 2
STEP 3
STEP 3
STEP 5 STEP 5
STEP 7
Remove rubber sleeves from back side of the
two top tubes of the IQ-1000 or IQ-2000.
Slide on Small Friction Sleeve to desired
position. Leave at lest 1.25” clearance from the
end of the tube for the 2nd Tier Assembly.
A.
(
2
)
Tier Assemblies
B.
(
2
)
Small Friction Sleeves
C.
(
2
)
Z-nobs
D.
(
2
)
Washers
E.
(
2
)
Hex Nuts
Make sure the plastic red triangle is at the joint.
This helps keep the joint open for sliding the 2nd
Tier Assembly into place.
Loosen z-knob until resistance is gone. You do
not have to completely unscrew for hex nut to
adjust second tier.
Pull tier to the outside of the IQ-1000
or IQ-2000.
Fold stand into closed position and push 2nd tiers in. Tighten
2nd tier z-knobs.
While holding the plastic red triangle, slide the
2nd tier into the top tube.
Remove the plastic red triangle when Tier
Assembly is fully in.
Install hand z-knob, washer, and hex nut. It
is important to place the hand knob on the
inside or stand will not fold fully. Also, be
careful not to over-tighten the hand knobs
because over-tightening may case cracking
of the collar.
Repeat steps 1-7 with other 2nd Tier Assembly.
In preparation for STEP 3, use water and soap to
lubricate tube.
A.
B.
C.
D.
E.
IQ-200 SETUP INSTRUCTIONS
IQ-200 TEAR DOWN INSTRUCTIONS
PARTS INCLUDED IQ-200 SETUP INSTRUCTIONS (Continued)
STEP 8
Z-nobs, washer, and hex nuts are assembled together. Remove
hex nuts when adding to tier assemblies.
STEP 2
STEP 4
Plastic red
triangle