Operation Manual

3
ULGD 3.8 A1
GB
appliance safely and are aware of
the potential risks. Children must not
use the appliance as a plaything.
Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
■ Do not use the charger for charging
non-rechargeable batteries.
■ Do not use the charger for charging
lithium-ion batteries.
■ Place the removed battery in a well-
ventilated location during charging.
■ The automatic mode of operation
and usage restrictions are explained
below in these operating instruc-
tions.
DANGER OF ELECTRIC SHOCK!
■ Do not operate the appliance with
a damaged cable, supply cord or
mains plug. A damaged power cord
causes danger to life by electric shock.
■ If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
■ Before connecting to the power,
ensure that the power connection is
earthed, is 230 V ∼ 50 Hz, and is
16 A fused and equipped with an
RCCB switch (residual current circuit
breaker) in accordance with the cur-
rent regulations!
■ Disconnect the charger from the grid,
before you make or break connec-
tions to the battery.
■ Always connect the positive termi-
nal clamp (red)
first.
■ The negative terminal clamp (black)
must be connected to the chassis
at least 10 cm away from the bat-
tery and the fuel line.
■ Now connect the charger to the
power supply.
■ After charging, disconnect the
charger from the grid. Only after this
remove the clamp from the body-
work. Following this, remove the
clamp from the battery.
DANGER OF EXPLOSION
AND FIRE HAZARD!
Protect yourself from a highly explo-
sive hydrogen-oxygen reaction!
■ Ensure that during charge and
charge retention procedures, there
are no naked lights (flames, cinders
or sparks)!
■ Ensure that the plus cable does not
come into contact with fuel lines
(e.g. petrol pipe)!
■ Ensure that there is no possibility of
ignition of explosive or flammable
substances, such as petrol or sol-
vents, while using charger!
■ Ensure that there is adequate venti-
lation during charging.