Specifications

Electrical power
Work performed on electrical equipment must be carried out
by competent personnel, trained for such work. The power
supply must be switched off and locked before work is
performed.
Sound level in hoist car
Sound level in the hoist car during travel was measured at:
≤ 85 db(A).
Spare parts
Unauthorized spare parts are not to be used. Only ”Alimak
Genuine Spare Parts” are to be installed.
The user’s own protective measures
Authorization of hoist personnel
A routine that guarantees continuous product training
(Authorization), that was done during the hoist installation,
must be set and maintained by a responsible person.
Contact Alimak or an Alimak representative, if this training is
required.
Protection at the landings
It is recommended that overhead protection is furnished at
landing entrances to protect against falling objects.
Accessible areas adjacent to hoistway
Scaffolding, platforms and other accessible areas located closer
than 0.5 m (1 ft. 8 in.) must be provided with 2.0 m (6 ft. 7 in.)
high enclosures or in accordance with applicable local
regulations.
With safety distance 0.5 m (1 ft. 8 in.) or more a 1.1 m
(3 ft. 7 in.) high two row safety railing with toe boards is
sufficient – if the hoist speed is 0.7 m/sec (135 fpm) or less.
For speed more than 0.7 m/sec. (135 fpm) the safety distance
must be increased to 0.85 m (2 ft. 9 in.) according to
SS - EN 12159 # 7.1.2.2.
Illumination of landings
The adequate site lighting shall be provided to illuminate the
landings over the full height of travel of the hoist.
Landings erected at site
Each landing shall be dimensioned for the maximum load of
the hoist and fulfil the above stated criterias regarding safety
distances.
ALIMAK 34598 - 1 /09
C 3