Specifications

Lubrication diagramxxxxxx
INTERVAL ITEM LUBRICATING POINT LUBRICANT VOLUME INSTRUCTIONS
60 operating hours 1 Gear box/-es Check the oil level.
or at least once a
2 Safety device, and
Shell Gadus S3 V100 C
Grease nipple.
month
idle gear on the rear of or equivalent
the plate where applicable Part No. 3001 396-250
3 Rack Alimak spec. grease We recommend use of a
Also use spray to Part No. 3001396-108 hand held battery operated
corrosion on the grease pump. Refer to
machinery pull rod´s cup product sheet No. 1291.
springs where applicable Alternative: Lubricate during lowering.
Cog spray for open gear Take lift out of operation
for 2 – 3 hours to permit the
spray to congeal.
4 Cable support arm, guides Ali-low-fric compound Grease slide surfaces. Do
and trolley, where applicable. Part No. 9052 045-000 not grease mast tubes – the
cable trolley may get stuck
120 operating 9 Door interlocks and ramps Shell Gadus S3 V220 C Grease bearings and slide
hours or at least Part. No. 3001 369-107 surfaces.
6 times a year
11 Landing doors Shell Gadus S3 V220 C Grease bearings and slide
or
equivalent
surfaces.
– Roof trapdoor and electric Spray can with multipurpose
cabinet hinges oil type WD 40 or equivalent
– Electric / hydraulical Hydraulic oil according to Check oil level.
load ramp – where applicable ISO VG32 or Also see page E23.
Q8 Hindemith LT
P/N. 3001 225-020
1000 operating – Hydraulic oil buffers – where Hydraulic oil according to Check oil level.
hours or at least applicable ISO VG68 or stroke 435 mm = 3.3 lit.
once a year Shell Tellus 68 (1’- 5 1/4’’ = 0.87 US gal.)
P/N. 3001 225-102 stroke 173 mm = 1.45 lit.
( 6 3/4’’ = 0.38 US gal.)
2000 operating 20 Gear box/-es Alioil VN Change oil, 2.9 lit.
hours or at least Part No. 9041 980-000 (0.76 US.gallon)
every 2 years
The lubricating oil grades indicated above have been used when the equipment is delivered from the factory. Only oil recommended
by ALIMAK shall be used. If, for some reason, this is not possible, please contact ALIMAK or ALIMAK Representative for advice.
E 22
WARNING!
Falling hazard.
Always use a fall arresting device if there is a need to climb
above the safety railing to reach the rack or items to grease or
inspect.
Can cause severe injury or death.
WARNING!
Lubricant harmful in contact with skin and lungs
Always use protective gloves and dust mask.
Possible risks of irreversible effects.
See applicable MSDS (Material Safety Data Sheet). Web site:
www.alimak.com
ALIMAK 34626 - 1 /09