Specifications

Resetting
1. Switch off the car main switch.
2. Unscrew the screws (1) and remove the cover (2).
3. Unscrew the screws (3).
4. Use the sleeve (5) and the cranking lever (4) to back off
the nut (7) until the end of the pin (6) is on a level with
the end surface of the safety device.
5. Install the screws (3) and the cover (2) with the screws (1).
6. Remove the protective cover (9).
7 Tighten the screw (8) by hand as far as possible and then a
further 30° by means of the sleeve and the cranking lever
(4) – in the direction indicated by the arrow on the cover.
8. Reinstall the protective cover (9).
9. Switch on the main switch and run the car up minimum
20 cm (8 in.) upward to reset the centrifugal weight of the
safety device in its neutral position.
10. Make a test run.
From a safety point of view the safety device must
never be dismantled more than is necessary to reset it as
described above. For this reason the safety device is sealed.
ALIMAK 34625_B - 1 /08
Tightening
torque 20 Nm
e 21
E 21