Specifications

Optional centrifugal brake1.
WARNING!
Unintended operation
Bring the car down to rest on the buffer springs.
Switch off, lock and tag the main switch before
inspection can take place.
Can cause severe bodily injury or death.
Inspection of brake and brake lining
1. Disconnect the flexible ball joint (A) from the control
device on the side where the Teleflex wire from the car
release lever is located.
2. Loosen the vertical bolt (B) on the brake housing, which
locks the control device axially.
3. Remove (pull out) the whole control device (C).
4. Inspect the brake lining through the seat (hole) for the con-
trol device.
Replace the brake linings when they are worn down to 3
mm (.12”) thickness.
5. Turn the control device on the opposite (right) side to check
that the lock ring disengages from the brake hub.
6. Lubricate the control device with Aeroshell Grease 6 when
reassembling.
Every 2nd month
1. Lubricate linkage and control cable with multipurpose oil
in a spray can, type WD-40 or equivalent.
Use the spray can’s additional extension tube to apply the oil
inside the control cable’s external hose.
E 16
C
A
B
D
e 111
ALIMAK 35039 - 1 /06