Specifications

Sliding
1. First check applicable items on previous page.
2. Switch off the main ON/OFF switch on the electrical
cabinet.
Manual sliding with the motor brake lever
– Open the trap door and climb to the car roof.
– Lift the brake lifter/-s on the motor to allow the car to slide
down to the next lower landing.
IMPORTANT: Only slide short distances with maximum
1/3 of normal operating speed. Stop at least 5 (five)
minutes every 20 meters (65 ft.) so that the brakes have
time to cool off. Overheating can cause the brake function
to deteriorate.
Sliding by means of optional centrifugal brake
– Pull the brake release handle downwards and keep it down
to allow the car to slide down to the next lower landing.
IMPORTANT: Always lower handle to its most bottom
position to prevent overheating of motor brake.
Release the handle immidiately if power suddenly comes
back and the lift starts.
If sliding of the car is not possible – stay in the car and call for
assistance.
Construction hoist with electrohydraulic load ramp
Construction hoists with foldable electrohydraulic load ramp
must be lowered gradually, in steps to the bottom landing to
offer passengers to leave the car in a safe manner – via the
entrance door.
Reason for this is that the electrohydraulic load ramp cannot
be operated without electrical power.
DANGER!
Falling hazard.
Take no risks exiting the car – wait for assistance.
Will cause severe personal injury or death.
ALIMAK 34606 - 1/10
D 7
d 34
Brake release
handle inside
the car
The 3rd el motor brake can be disengaged
with an ratcheted tie down, where
applicable.
It is possible to manually slide
the machinery with the lever on
the centrifugal brake too