Specifications

Control equipment, ALC with keypad
Press the button(s) for required landing. The hoist will auto-
matically stop at the selected landing.
Example:
If you want to stop at the 12th landing;
Push button 1 + 2 and end finish by pushing the ENT. button
When carrying out service and inspection work
When it is necessary to operate the hoist from the car roof, in
order to carry out service and inspection work, the switch in the
electric cabinet in the hoist car shall be set in the ”Inspection”
position. The switch then breaks the self-holding function of the
control system and the landing control circuits. This means that
the hoist will stop as soon as the push button / joystick is
released and that the hoist can only be operated from the roof of
the car.
Additional functions ’’Run enable’’ and ’’Soft-stop’’
Frequency converter operated hoists have both feature ’’Run
enable’’ and ’’Soft-stop’’ working together on the same push-
button.
The features are used according to the following but in
Inspection mode, only:
– First push the ’’Run enable’’ push-button marked with an
opened up padlock.
– Choose direction and push the ’’Up’’ or ’’Down’’ push-
button.
– Release the ’’Up’’/’’Down’’ push-button at the intended
level – but keep the ’’Run enable’’ push-button depressed
until the hoist stops.
Selector switch ”Car only”
The selector switch ”Car only” (marked -S 107) inside the
B-panel disconnects all signals from the landings, which means
that the hoist can only be operated from inside the car.
Ensure that this switch is actuated when intended to run the car
in operator control mode only.
ALIMAK 34602 - 1 /05
D 3
a 86
Note: This switch is located outside
the car roof electrical panel for hoists
delivered to Australia.