Specifications

Inspection after major modifications or accidents
Inspection and testing should be carried out after major
modifications or after an accident to make certain that the
hoist operates properly.
Working under the hoist car
When working under the hoist car, always secure the car
mechanically, by safe means, i.e. the car to mast lock device.
Or other suitable certified object.
The hoist’s main disconnect switch must always be turned off
and padlocked during the operation.
Transportation of pallet truck or other wheeled equipment
in the hoist car
To prevent such equipment due to malfunction or negligence,
may run out of car, stop blocks of rubber or similar mechanical
stop on the car floor to be constructed to prevents this.
Pallet truck/ equipment including load must not exceed max.
load acc. to load sign in the car.
Maximum allowable point load on the car floor from a 100 mm
(4’’) wide roller of dia. 100 mm (4’’):
Plywood floor = 500 kg (1100 lbs.) / roller
Aluminium type sandwich floor = 1000 kg (2200 lbs.) / roller
Loading/ unloading of the above mentioned equipment must
be performed with lowest possible speed.
Stacked goods
Stacked goods on pallet or similar that may slide or collapse
shall always be properly secured in a safe manner with respect to
the risk of crushing.
At the end of the shift
ALWAYS drive down and park the hoist at the base landing,
where the machine’s best possible location is, if extreme high
wind speeds should occur.
Also switch off and lock the main switch with a padlock to
prevent unauthorized use.
ALIMAK 35054 - 1 /09
C 4
Stop blocks of rubber
Part. No. 9115148-000
Assemble several blocks using a rope,
chain or threaded rod to suit the
equipment in question to be transported