Instruction manual
-- 5 --
bu15d1ea
NB: These instructions describe an AristoMig U500 with a cooling unit.
The power source is intended for use with the AristoFeed 30 or AristoFeed 48 wire
feed units.
All the settings are made from the wire feed unit or control box AristoPendant U8.
ESAB’s accessories for the product can be found on page 17.
3.1 Equipment
The AristoMig U500 power source is supplied complete with terminating resistor, 5m
return cable and instruction manual.
4 TECHNICAL DATA
AristoMig U500
Mains voltage 400V, ±10%, 3∼ 50/60 Hz
Primary current
I
max
MIG/MAG
I
max
MMA
I
max
TIG
39 A
40 A
31 A
No--load power demand when in the energy--saving mode,
6.5 min. after welding
50 W
Voltage/current range
MIG/MAG
MMA
TIG
8-- 60 V / 16--500 A
16-- 500 A
4 -- 500 A
Permissible load at MIG/MAG
60 % duty cycle
100% duty cycle
500 A / 39 V
400 A / 34 V
Permissible load at MMA
60 % duty cycle
100% duty cycle
500 A / 40 V
400 A / 36 V
Permissible load at TIG
60 % duty cycle
100% duty cycle
500 A / 30 V
400 A / 26 V
Power factor at maximum current 0.85
Efficiency at maximum current 86 %
Open --circuit voltage
MIG/MAG
MMA
TIG
72 -- 88 V
68 -- 80 V
72 -- 88 V
Operating temperature -- 1 0 t o + 4 0 ˚C
Dimensions, lxwxh
with cooling unit
625 x 394 x 496 mm
625 x 394 x 776 mm
Continual A--weighted sound pressure <70 db
Weight
with cooling unit
69 kg
89 kg
Insulation class transformer H
Enclosure class IP 23
Application class
GB