Instruction manual

-- 8 --

bu20d1ea

6OPERATION

General safety regulations for the handling of the equipment can be found on

page 3. Read through before you start using the equipment!

6.1 Connections and control devices

1 Connection for cooling water from the TIG

torch -- RED

10 White indicating lamp -- Power supply ON

2 Connection with ELP* for cooling water to

the TIG torch -- BLUE

11 Orange indicating lamp -- Overheating

3 Cooling water filler 12 Fuse4AT

4 Connection for welding current cable (+)

at MMA welding or for return cable at TIG

welding

13 Connection for control cable to the wire

feed unit or to the terminating resistor

5 Connection for remote control adapter 14 Connection for gas hose

6 Connection for return cable (--) or for wel-

ding current cable at TIG welding

15 Connection for welding current to the wire

feed unit

7 Connection for start signal from the torch. 16 Connection for cooling water to the wire

feed unit -- BLUE

8 Connection for gas to the TIG torch 17 Connection for cooling water from the wire

feed unit -- RED

9 Main power supply switch, 0 / 1 / START

* ELP = ESAB Logic Pump, see point 6.5