User Manual

UIOT Special for technical documents
Through the "UIOT smart home" APP, you can:
1) Check the current device switch status.
2) Control socket on and off.
3) Add device actions to the scene to achieve one-key control of the
device.
4) Add device action to linkage and timing to realize automatic
control of equipment.
5) Authorize different device actions for different user roles.
6) Follow any user, and the APP will receive notification after the
user operates the device.
7) Get help, mine - help, get more guidance to use.
Technical Specifications
1. Appearance size: 74mm*119mm*53.8mm;
2. Operating voltage: AC120-125V 50/60Hz;
3. Operating temperature: -10℃~40℃;
4. Working humidity: <95% RH(no condensation);
5. Communication mode: ZigBee
6. Total load: resistive load ≤1800W.
Note: make sure the product load meets the above requirements to avoid
accidents!
CAUTION
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2 )This device must accept any interference
received, including interference that may cause undesired operation.
NOTE1:This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,