User's Manual

- 14-
Quick Call: Check the box to enable this function. It refers to the call to
management center. Enter the SIP address of specified management center
device in the box after URL. The device can be indoor monitor or SIP phone of
other manufacturers.
Check the box of Voice GW to enable voice gateway. The settings are as
follows:
1. Connect LAN port of voice module to the computer through the switch, set the
computer's IP address to 192.168.2.*, open IE browser, and enter http:
//192.168.2.1 and default password "admin" to the setup interface;
2. According to the situation of used internet, assign appropriate IP address to
WAN port of voice module (IP of WAN port cannot be on the same network
segment as the one of LAN port. If WAN port is set to 192.168.2.*, the gateway of
LAN port will be adjusted automatically rather than 192.168.2.1). Enable the
access permission of WAN port and click "Apply".
3. FXO port settings: set the SIP user ID of the port, set DTMF mode to RFC2833
and click "Apply".
4. IP address of WAN port for voice gateway is the one of URL for system
development module of outdoor panel. The final port No. is default port of the
system. The format of URL bar is: [SIP user ID of FXS port] @ [IP of WAN Port]:
5062.
5. Once this is set up, click "Submit" to enable new settings.
Speed Dial: press a number key to call directly;
ONU Pass: check out ONU settings;
4G Dongle: check the box to enable 4G Internet;
RTSP Feed: check the box to bind media address of third-party video network
management.
Once this is set up, click "Submit" to enable new settings.