Instructions
Table Of Contents
- 1. Safety and compliance
- 2. Introduction
- 3.5 Firmware update
- 3.4 First setup
- 3.3 Hardware installation
- 3.2 What's in the box?
- 3.1 Unboxing
- 4.6 Change the printer configuration
- 4.5 Remove the print
- 4.4 Printing with the Air Manager
- 4.3 Preparing a print with Ultimaker Cura
- 4.2 Materials
- 4.1 Touchscreen
- 5.4 Replace the Air Manager filter
- 5.3 Maintenance schedule
- 5.2 Material handling and storage
- 5.1 Update the firmware
- 6.4 Air Manager troubleshooting
- 6.3 Adhesion issues
- 6.2 Extrusion problems
- 6.1 Error messages
- 7.5 Applicable law and competent court
- 7.4 Exclusions
- 7.3 Notification
- 7.2 Conditions
- 7.1 General
