Instructions
Table Of Contents
- 1. Safety and compliance
- 2. Introduction
- 3.5 Firmware update
- 3.4 First setup
- 3.3 Hardware installation
- 3.2 What's in the box?
- 3.1 Unboxing
- 4.6 Change the printer configuration
- 4.5 Remove the print
- 4.4 Printing with the Air Manager
- 4.3 Preparing a print with Ultimaker Cura
- 4.2 Materials
- 4.1 Touchscreen
- 5.4 Replace the Air Manager filter
- 5.3 Maintenance schedule
- 5.2 Material handling and storage
- 5.1 Update the firmware
- 6.4 Air Manager troubleshooting
- 6.3 Adhesion issues
- 6.2 Extrusion problems
- 6.1 Error messages
- 7.5 Applicable law and competent court
- 7.4 Exclusions
- 7.3 Notification
- 7.2 Conditions
- 7.1 General
6
1
3 4
5
7
8
9
1013 12
11
2
1
7
6
5
3
4
2
89
Ultimaker 2+ Connect - Manual de instalación y uso 10
Ultimaker 2+ Connect
Air Manager
1. Filtro
2. Cubierta
3. Manija
1. Cabezal de impresión
2. Cable del cabezal
de impresión
3. Placa de impresión
4. Abrazaderas de
la placa de impresión
5. Pantalla táctil
6. Puerto USB
7. Tubo Bowden
8. Alimentador
4. Carcasa frontal
5. Perl de bisagra
6. Ventilador
7. Carcasa del ltro
8. Cable de Air Manager
9. Clip para desinstalar
Air Manager
9. Interruptor de encendido
10. Puerto OUT
11. Toma de corriente
12. Soporte de bobina
13. Puerto Ethernet port