Instructions
Ultimaker 2+ Connect user manual 28
5.1 Update the rmware
Periodically, a new version of the Ultimaker 2+ Connect rmware is released. To ensure that your Ultimaker 2+
Connect is equipped with the latest features, it is recommended to keep the rmware updated to the latest version.
Update over the network
If the Ultimaker 2+ Connect is connected to a network, it automatically checks for available rmware updates. When
a new rmware is available, the printer will prompt you to download and install it via the touchscreen interface.
Alternatively, check for updates manually by navigating to Settings → Update rmware.
Do not power o the printer during the rmware installation.
Update using a USB stick
If your Ultimaker 2+ Connect is not connected to a network, you can update to the latest rmware via USB.
The rmware les are found on the Ultimaker website:
1. Navigate to ultimaker.com/rmware, and select your printer
2. Download the rmware image and store it in the root directory of your USB stick
3. Insert the USB stick into the USB port of the printer
4. Go to Settings → Update rmware and select the new rmware from the USB device
Do not power o the printer during the rmware installation.
5.2 Material handling and storage
Opened material spools must be stored properly when not in use. If material is stored incorrectly, it may aect its
quality and usability.
The optimal storage temperature for PLA, Tough PLA, Nylon, CPE, CPE+, PC, TPU 95A, and PP is between -20 and
+30 °C. For ABS, the advised temperature is between 15 and 25 °C. Furthermore, a relative humidity of below
50% is recommended for TPU 95A and PP. If these materials are exposed to a higher humidity, the quality of the
material can be aected.
To keep your materials in optimal condition, opened spools should be stored:
• Cool and dry
• Out of direct sunlight
• In a resealable bag
To minimize moisture absorption, store the material in a resealable bag including the supplied desiccant (silica gel)
directly after printing.