User`s manual

22 CaptionMaker for Windows
Now back in the main SETTES32 program, select Exit + Save Permanently. This will both
save your data and take your encoder out of setup mode. After choosing this, the program
may not seem to do anything for anywhere from 1-3 minutes. Let it go, it is actually
communicating with the encoder and updating any settings you may have changed, as well as
exiting the encoder out of setup mode.
Configuring CaptionMaker
You can now disconnect the NULL MODEM CABLE from PORT A to COM1, leaving only
the network and power cables connected. Now, from any computer with internet access, you
can connect to the encoder. To connect from the CPC CaptionMaker program, select Caption
→ Device. Choose Norpak Encoders as your device, and press configure. Select the Connect
via Local Area Network (LAN) button as your connection method, and enter in the IP
Address you assigned to your encoder (If you used DHCP, the IP Address you should use is
the “actual” IP address of the router, not the local IP Address of the encoder.) Enter the
correct port, and press OK. As soon as you attempt to send a caption line or enter into the
Live Caption mode, the program will attempt to connect to your encoder. If you followed the
instructions carefully up to this point and did everything correctly, you will immediately be
connected to the encoder and will be able to send caption data directly to it through the
internet.