User`s manual

Updates since version 2.25 21
program must check all of the encoder’s numerous features before allowing you to edit
anything. The connection process may take 1-3 minutes.
Once connected, a TES Setup Program window will appear with quite a few options. The
first things to check are to make sure that the Encoder field (located at the top right of the
program) is set to 525 Line. Also make sure that the Insert Block is set to 10-25.
You must put the encoder in LAN Mode . This can be done by clicking Configure at the top
right of the Settes32 program, and selecting LAN Encoder at the bottom left of the window
that pops up. If it was originally set to Serial Encoder you may have to delete the caption
streams by Restoring factory defaults . If it is not already set to LAN Encoder and you have
to change it, you will have to exit and save changes permanently, then restart the encoder in
setup mode and run the SETTES32 program again before you can make any changes.
The next area to check is the Stream Setup part of the program. Your encoder’s defaults
should be set to: Stream 1: Closed Caption Encoder
If your encoder is in LAN mode, then the port for the Stream 1 Encoder will be a number,
like 2000. If your encoder is in Serial Mode, the port will be set to Port A. If it is still set to
Port A, you MUST change the encoder to LAN mode by following the steps above before
you can proceed.
IP Address & Port
If the port is set to 2000, it should be fine. For more information on how to configure the
Closed Caption Stream or the NABTS Data Broadcast Software, please read Chapters 7 and
4, respectively, in your Norpak Encoder Software User’s Manual.
The important thing we want to change in this program is located in the bottom left area of
the program: TCP/IP Address. Click on Properties to open the TCP/IP window.
If you are not familiar with your company’s network, you should contact your network
administrator and ask for his help.
In the Properties window, we have a few fields to fill out. If you are not using DHCP you
must have a Static IP Address. Enter the IP Address and the Subnet Mask for the encoder. It
is recommended that you set the port to 2000. Regardless of what you set the port to, it
MUST match the port shown in the Stream 1: Closed Caption Encoder port! Make sure that
DHCP is set to OFF, and press OK.
If you are using DHCP, simply click DHCP ON and make note of the LAN 1 port (Default
2000). When using DHCP, you do not have to enter an IP Address, or a Subnet Mask. Press
OK. If you are using DHCP, that probably means you are behind a router. It is extremely
important that you or your network administrator configures your company’s router to open
the LAN 1 port specified in SETTES32. If not, you will be unable to connect to the device.