User`s manual

20 CaptionMaker for Windows
Exit and save permanently, mirror changes in CaptionMaker, and it should work.
LAN/Internet Connection
A transmit computer, executing the SETTES32 configuration program, is required to
configure the encoder before it can be a “Standalone” internet encoder. A configuration
program, SETTES32, should have been supplied with your encoder on a floppy disk. To
install SETTES32 on the transmit computer, run SETUP.EXE located on the floppy disk.
Configuring the Encoder
Once SETTES32 has been installed, it is time to connect the computer to the encoder so that
we can configure a few things. Using a 9 pin female to 9 pin female NULL MODEM
CABLE which should have been supplied with your encoder, connect PORT A on the
encoder to COM1 on your computer. You should also connect a network cable with a static
IP service or DHCP service to the encoder for later use.
Next, put the encoder in setup mode. In order to do this, you must first turn the encoder off.
Using a pencil or a pen, press in the LOAD switch and turn the machine back on. Hold the
LOAD switch down for at least 5 seconds, and your encoder will be in setup mode. We can
now run SETTES32.
You will be prompted to choose a connection. Choose Serial Port. The next prompt will ask
Configure using port: COM1? . If you are using COM1, choose Yes, if not, select No and
enter the COM port you are using manually into the program.
The program will now attempt to connect. If you connected everything correctly and put your
encoder in setup mode, you will be able to connect and watch the connection progress. The