User`s manual

Updates since version 2.25 19
The program will now attempt to connect. If you connected everything correctly and put your
encoder in setup mode, you will be able to connect and watch the connection progress. The
program must check all of the encoder’s numerous features before allowing you to edit
anything. The connection process may take 1-3 minutes.
Once connected, a TES Setup Program window will appear with quite a few options. The
first things to check are to make sure that the Encoder field (located at the top right of the
program) is set to 525 Line. Also make sure that the Insert Block is set to 10-25.
You must put the encoder in Serial Mode. This can be done by clicking the Configure button
at the top right of the SETTES32 program, and selecting Serial Encoder at the bottom left of
the window that pops up. If it was originally set to LAN Encoder you may have to delete the
caption streams by Restoring factory defaults. If it is not already set to Serial Encoder and
you have to change it, you will have to exit and save changes permanently, then restart the
encoder in setup mode and run the SETTES32 program again before you can make any
changes.
Once this has been done, add a closed caption Stream to Stream1. Configure
→ Port A / set
settings like 9600 baud stop bits 1 parity 8 etc. Choose output stream to be line 21.