User`s manual

18 CaptionMaker for Windows
Norpak Encoder TES3 and TES5
(Captioning via LAN connection)
A configuration software SETTES32 is supplied with your encoder on a floppy disk. To
install SETTES32, run SETUP.EXE located on the floppy disk. If you have an older version
of Norpak encoder, you have to use an older version of the software.
Once SETTES32 has been installed, it is time to connect the computer to the encoder so that
we can configure a few things. Using a 9 pin female to 9 pin female Null modem cable
special cable provided by Norpak) which should have been supplied with your encoder,
connect PORT A on the encoder to COM1 on your computer.
Next, put the encoder in setup mode. In order to do this, you must first turn the encoder off.
Using a pencil or a pen, press in the LOAD switch and turn the encoder power on
. Hold the
LOAD switch down for at least 5 seconds, and your encoder will be in setup mode. Now run
the TTES32 software and choose the Captioning Module. You will the following screen.
Serial Port Connection
You will be prompted to choose a connection. Choose Serial Port. The next prompt will ask
Configure using port: COM1? . If you are using COM1, choose Yes, if not, select No and
enter the COM port you are using manually into the program.