Instruction manual

HDE-3000 - 73 -
The HDE3000 Dual software has been enhanced to facilitate this using one dual unit
instead of two single units. The following diagram illustrates the equipment connections.
ENC 1
“Decode”
V in
ENC 2
“Encode”
V in Vout
Com2
Time Taylor
V in Vout
(Com)
Info out
HD Video in
(with ATC)
HD Video out
6 second dela
y
V in Vout
HDE3000 Dual
7.3 Dual Configuration
ENC 1: Time Code Source Menu
: set to “ATC” to use ancillary time code.
ENC 1: COM1 Setup Menu
:
set function to “Redirect Data”
set Baud Rate to 9600
set Format to “8-none-1”
set source to “Upstream TC+F1+F2”
ENC 1: COM2 Setup Menu
:
set function to “Disabled”
ENC 2: Time Code Source Menu
: set to “ATC” to use ancillary time code.
ENC 2: COM1 Setup Menu
:
set function to “Disabled”
ENC 2: COM2 Setup Menu
:
set function to “Redirect Data”
set Baud Rate to 9600
set Format to “8-none-1”
set source to “TIME TAYLOR”
set status to “buffer stopped” (used to start/stop the job, see “operation”)