Instruction manual

HDE-3000 - 18 -
3. Network Configuration
3.1 Network Setup
The HDE-3000 will run normally with no network connection, but the ability to
load and run Interactive TV, caption, subtitle or script jobs from a network server will
not be available.
The HDE-3000 networking is configured at the factory as follows:
Client: Microsoft Network Client
Protocol: TCP/IP
IP address: Automatically obtain IP address via DHCP
Computer Name: HDE3000-xxxx (where xxxx is the serial number of the HDE-3000)
Workgroup Name: WORKGROUP
For many customers this configuration is acceptable and no adjustments to
the HDE-3000 network configuration are necessary. If your HDE-3000 network
configuration requires modification then perform the following procedure:
1. Connect a VGA monitor, keyboard, and mouse (a mouse is not necessary but
recommended) to the HDE-3000. Note that if the unit was booted without a mouse
connected then it may be necessary to re-boot the unit with the mouse connected to get
the mouse to function.
2. The HDE-3000 displays several status items on the VGA monitor via an On-Screen
Display Application. Hold down the ALT key and press TAB to minimize the display
application and reveal the Windows desktop. You can switch back to the display
application at any time by clicking the “HDE3000 Remote” icon in the task bar.
3. Select the Start Menu, then Settings, then Control Panel. Then double click the
Network icon.
4. You may now change the computer name, workgroup name, or TCP/IP protocol
properties as required for your network.
3.2 Network Administration
The following accounts are set up on an HDE-3000 when it is configured at the
factory: Administrator account: login = Administrator, password = Administrator
Operator account: login = Operator, password = blank (no password)
For many customers these accounts are acceptable and no adjustments are
necessary. If these accounts need to be modified or new accounts need to be added
then refer to the following procedures.