Instruction manual

HDE-3000 - 16 -
2.7 Front Panel Controls and Indicators
1. Power on/off switch. IMPORTANT NOTE: never shut off unit without first running the
“Shutdown” procedure (see section 5.8.1 “Shutdown Menu”).
2. Reset. The HDE-3000 contains a reset button which is recessed inside the front
panel. Pushing this button will cause the HDE-3000 to perform a power-on reset.
3. USB ports, for using USB drives to load jobs into unit or to upgrade the unit.
4. Program Video LED. Illuminates when HDE-3000 detects proper incoming video.
5. Encoding LED. Illuminates when HDE-3000 is actively encoding data into the VANC
portion of the incoming HD-SDI video.
6. Data In LED. Illuminates when HDE-3000 detects data at its RS-232 or modem
inputs.
7. Time code LED. Illuminates when LTC time code is detected.
8. Hard Disk LED. Illuminates when HDE-3000 reads or writes from its hard drive.
9. Setup LED. The red Setup LED illuminates when you are in setup mode. In setup
mode, on-screen menus are displayed on the decoder monitor.
10. Floppy Drive. The HDE-3000 can read closed caption, subtitle, and scripts via this
drive. Graphics files should be loaded using the network or USB drives because of
their large size. New units will not have a floppy drive installed in them.
11. Cursor keys. Press ENTER to bring-up the on-screen menu. Press the left, right, up,
down cursor keys together with the
ENTER key to move through the menus and
make selections.