Instruction manual

HDE-3000 - 11 -
2. Installing and Operating Instructions
2.1 Installation procedure
The following is the recommended installation and setup procedure when an HDE-3000
is installed at the customer site:
1. Unpack HDE-3000 from its shipping container. Please retain the original shipping
container, if it is ever necessary to ship the HDE-3000 to the factory for service, this
specially designed double-box container will prevent the unit from being damaged during
shipment.
2. Mount the HDE-3000 into a standard 19 inch equipment rack, leaving 6 inches of space
behind the unit for ventilation. It is not necessary to mount the HDE-3000 in an
equipment rack, but it is recommended.
3. Connect power to the HDE-3000. It is recommended that the HDE-3000 be
powered from a clean, uninterruptible power source.
4. To connect the HDE-3000 to your network, connect a category 5 network cable to the
NETWORK connector and refer to section 3.1 Network Setup. A VGA monitor and
keyboard may be connected to the HDE-3000 at any time (a VGA monitor is required
for normal HDE-3000 operation); a mouse may be connected prior to boot-up.
Power
Apply AC line power to the unit via the detachable three wire cord.
Grounding (earth ground)
The HDE-3000
must be connected to a protective earth conductor via the three
wire AC line (mains) cord. The AC power plug shall be inserted only into a receptacle
outlet that has a protective earth contact. The ground wire must not be defeated by use
of a two wire extension cord.