Instruction manual

HDE-3000 - 106 -
Version 1.55
Enhancement: Decode 708 Services 3 thru 6
The VGA screen decoders and the open caption decoder can now decode CEA-708
services 3, 4, 5, and 6. Previous versions could only decode services 1 and 2.
Enhancement: Support for MCC files
The ability to read and encode CPC MCC files was added. These files have the
extension *.mcc. Version 1 and version 2 MCC files are supported. The HDE3000 can encode
the following data contained in an MCC file:
• Field 1 608 data (CC1, CC2, T2, T2)
• Field 2 608 data (CC3, CC4, T3, T4, XDS)
• 708 services 1, 2, 3, 4, 5, and 6
Version 1.56
Enhancement: Language Selection for Service Descriptors S1 & S2
The options are as follows; English (eng), Spanish (spa), French (fre), Portuguese (por),
German (ger), Danish (dan), Italian (ita), Finnish (fin), or Swedish (swe).
Refinement: Hard lock with long .MCC files
The unit will now run long .MCC files with out locking up.
Version 1.57
Experimental version not released
Version 1.58
Enhancement: Dual Link RGB 4:4:4 Subtitling
A new menu 7.7 has been added to allow proper subtitle insertion into dual link RGB
4:4:4 streams. First you will to take the UYC subtitles and convert it using the WinUycToUyc
V1.03 utility. You have to do this twice once for link A and once for link B. Two get the subtitle
insertion to be timed at the same frame you will need two units. Link A thru one unit and link B
thru the other unit. Set the new menu 7.7 to RGB 4:4:4, then load the subtitle jobs into the units
to match the link. This menu will have to be disabled to properly insert subtitles (graphic) into
single link YCrCb.
Version 1.59
Refinement: Improved NTSC frame rate detection
An improvement was added to the frame rate detector to allow it to better detect NTSC
frame rates (23.98/29.97/59.94). Occasionally the detector switch from NTSC frame rate to
computer frame rate (24/30/60). This switch would cause the graphic memory to clear.