User Guide

PAGE 1 OF 2 0521 IH-9523

1-800-295-5510

uline.com

H-9523, H-9524

BATHROOM MIRROR

PARTS

TOOLS NEEDED

Phillips

Screwdriver

Level Measuring

Tape

Drill Appropriate-Sized

Drill Bit

INSTALLATION

1. Verify all dimensions and wall space prior to

installation.

NOTE: At least 1½" of clear space is needed

above the mirror on the wall for easy

installation. (See Figure 1)

2. Hold mounting bracket on the wall where mirror will

be placed. Mark four holes where screws and wall

anchors will be placed. (See Figure 2)

Figure 1

1½"

Figure 2

Screw

Locations

Mirror x 1 Mounting Bracket x 1 Screw x 4

(not included)

Wall Anchor x 4

(not included)

PAGE 1
H-9523, H-9524 BATHROOM MIRROR 1-800-295-5510 uline.com TOOLS NEEDED Phillips Screwdriver Level Measuring Tape Drill Appropriate-Sized Drill Bit PARTS Mirror x 1 Mounting Bracket x 1 Screw x 4 (not included) Wall Anchor x 4 (not included) INSTALLATION 1. Verify all dimensions and wall space prior to installation. NOTE: At least 1½" of clear space is needed above the mirror on the wall for easy installation. (See Figure 1) Figure 1 2.
PAGE 2
INSTALLATION CONTINUED NOTE: Mirror will extend 2¼" above mounting bracket and 2" below bracket. (See Figure 3) Figure 3 5. Carefully slide mirror down onto the bracket, ensuring it locks into bracket tabs. (See Figure 6) Half Mirror Width Figure 6 2¼" Mirror Mounting Bracket Tab 2" 6. Try lifting mirror after installation. Unit was correctly installed if it does not slide off.