User`s guide

Dual Link 12
Dual Link 13
CREATING NEW PROJECTS
1. Run Video Studio. Click Start on the Step Panel.
2. Click New Project in the Options Panel. This opens the New Project
dialog box.
3. Specify a path to store captured files to be used in the project.
4. Select a template that matches your requirements. It is recommended
that you select a template that will be used for the target medium. Or,
if you want to use the template from a previous movie file you
created, select Template from an existing video file then click Browse
to locate the movie file.
Tips: Since you are capturing video from a DV/D8 camcorder, select
NTSC DV or PAL DV as the template to make your project settings the
same as that of the captured video. This speeds up rendering and lets
you preview your project a lot faster.
5. Click OK.
SETTING UP VIDEOSTUDIO 6 FOR DV
1. Make sure your camcorder is connected to your Dual Link PCI
tcapture card.
2. Double check that your camcorder is on and set to Play mode (usu-
ally labeled as VTR or VCR mode on most camcorders). Again, refer to
your camcorder’s manual for specific instructions.
3. Choose DV as the capture file format in the Capture Settings
Tab.VideoStudio then automatically enables the Ulead DirectShow
Capture Plug-in.
Note: To manually enable the capture plug-in, click Settings and
Commands and select Change Capture Plug-in. In the dialog box, select
Ulead DirectShow Capture Plug-in.
4. VideoStudio also automatically enables device control for your
DV camcorder. Test and see if you can control your camcorder from
VideoStudio. If you cannot operate your DV camcorder in VideoStudio,
see Troubleshooting DV device control for instructions on how to manu-
ally set up the device control.