Instructions / Assembly

ASSEMBLY/INSTALLATION INSTRUCTIONS

3LT PENDANT LIGHT

installation.

shock.

All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)

standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a

referencing the illustrations on the installation instructions.

Phillips screwdriver.

CAUTION

GENERAL

TOOLS REQUIRED

ASSEMBLY AND INSTALLATION

(CONT.)

Turn off the power at fuse or circuit breaker.

Turn on the power at fuse or circuit breaker.

IF IN DOUBT ABOUT ELECTRICAL INSTALLATION,

CONSULT A LICENSED ELECTRICIAN.

Please read carefully and save these instructions, as you may need them at a later date.

1. Gently take all parts out of the package, lay them on a smooth surface.Spread VERTICAL RINGS to an

equal distance apart and secure the TILT RINGS to VERTICAL RINGS with CAP NUTS and SCREWS.

3. Attach the NIPPLE to the MOUNTING BRACKET, then secure it with a WASHER and HEX NUT.

4. Attach the MOUNTING BRACKET to the JUNCTION BOX by using two JUNCTION BOX SCREWS.

5. Secure the TOP LOOP to the NIPPLE.

6.Choose the length of the CHAIN you need, then weave the FIXTURE WIRE and the FIXTURE GROUND

9. Pull out the SUPPLY WIRES and SUPPLY GROUND WIRE from the JUNCTION BOX. Make wire

connections using the WIRE CONNECTORS:

---Attach the FIXTURE GROUND WIRE to the MOUNTING BRACKET with the GREEN GROUND

SCREW.Then connect it to the SUPPLY GROUND WIRE with a WIRE CONNECTOR.

Carefully put the wires back into the JUNCTION BOX.

WIRE through the CHAIN, COLLAR and CANOPY

7. Open the top and bottom section of the CHAIN using a phillips screwdriver (not included) and pliers

(not included), then attach it to the LOOP. Close the CHAIN.

8. Thread the FIXTURE WIRE and FIXTURE GROUND WIRE through the TOP LOOP, NIPPLE and

MOUNTING BRACKET.

10.Attach the CANOPY to the MOUNTING BRACKET by inserting the TOP LOOP, then secure it with

the COLLAR.

11. Install BULB (not included). See relamping label at socket area or packaging for maximum allowed wattage.

2.Tighten the FIXTURE FINIAL into the FIXTURE.