Declaration of Conformity

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This radio transmitter [enter the device’s ISED certification number] has been approved by
Innovation, Science and Economic Development Canada to operate with the antenna types listed
below, with the maximum permissible gain indicated. Antenna types not included in this list that
have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for
use with this device.
No.
Antenna Type
Gain
Impedance
1
External uniqueness Antenna
2dBi
50ohm
IC Radiation Exposure Statement:
This device and its antenna(s) must not be co-located with any other transmitters except
in accordance with IC multi-transmitter product procedures. Referring to the
multi-transmitter policy, multiple-transmitter(s) and module(s) can be operated
simultaneously without reassessment permissive change.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec
une autre antenne ou transmetteur.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de
20cm de distance entre la source de rayonnement et votre corps.
This module is limited to OEM installation only and must not be sold to end-users,
end-user has no manual instructions to remove or install the device, only software or
operating procedure shall be placed in the end-user operating manual of final products.
Additional testing and certification may be necessary when multiple modules are used.
Any changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate this equipment.
The final end product must be labeled in a visible area with the following " Contains IC:
25239-UIOTZMV41 ".