Safety data sheet

Page 4/6
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 02.02.2011 Revision: 02.02.2011
Trade name: UHU plus endfest 300 (Härter)
(Contd. of page 3)
DR
Rubber gloves
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
Eye protection:
Safety glasses
9 Physical and chemical properties
·
Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Fluid
Colour:
Yellow
·
Odour:
Amine-like
·
pH-value at 20°C:
12 (1:1 in H2O)
·
Change in condition
Melting point/Melting range:
Undetermined.
Boiling point/Boiling range:
> 200°C
·
Flash point:
110°C
·
Self-igniting:
Product is not selfigniting.
·
Danger of explosion:
Product does not present an explosion hazard.
·
Density at 20°C:
0,95 g/cm³
·
Solubility in / Miscibility with
water:
Not miscible or difficult to mix.
·
Viscosity:
Dynamic at 20°C:
32500 mPas
·
Solvent content:
Organic solvents:
0,0 %
VOC (EC)
0,00 %
Solids content:
100,0 %
10 Stability and reactivity
·
Reactivity
·
Chemical stability
·
Thermal decomposition / conditions to be avoided:
No decomposition if used according to specifications.
·
Possibility of hazardous reactions
No dangerous reactions known.
·
Hazardous decomposition products:
No dangerous decomposition products known.
EU
(Contd. on page 5)