User's Manual

3 0000 #
To delete all users
Attention: Delete all PIN users & card
users except super open password.
To set a super
open password
3
Super open password # Repeat super open password #
Only can set one set of super open
password which has the highest
permission to open the door and it
can be used to open the door in any
door open mode.
0000 #
To delete the super open password
To set door
open mode
4
0 #
Entry is by either Card or PIN
(Default)
1 #
Entry is by Card and PIN together
2 #
Entry is by PIN only
3 #
Entry is by Card only
To set door
unlock time
5
XX #
XX is any number from 0 to 99.
The factory default setting is 3
seconds.
Advanced Application
6
1
XX #
To set Multi-cards to open the door
XX is any number from 1 to 10. The factory default setting is 1.
The door will open only when the quantity of the valid cards which
it reads is up to the quantity you set.
It is only for Card Only mode.
Alarm Setting
7
1
0 #
To set anti-tamper alarm
OFF (Default)
1 #
ON
System Setting
8
1
0 #
To set keypad output mode
Default value, to set the output mode of the keypad to Normal
Mode. After an unlock operation, the lock is unlocked, then the lock
will be locked automatically after the door unlock time you set is up.
1 #
To set the output mode of the keypad to Toggle Mode. After an
unlock operation, the lock will keep unlocking until there is another
unlock operation again, then the lock will keep locking, and so on.
Optional Setting
9
1
0 #
To Set Buzzer
ON (Default)
1 #
OFF
Remarks: All passwords can be 4 to 8 digits long, but you can't set every digit as zero.
Note that the following operations must be done out of the programming mode
To set or change a
PIN of an added card
## Read an Added Card PIN # Repeat PIN #
To reset to the
default admin
password
1）Disconnect power from the device
2）Press 00 # within 5 seconds after powering the device back up.
This operation only resets the admin
password to 123456, and it will not
delete the users and settings.
To reset to the
default factory
setting
1）Disconnect power from the device
2）Press 99 # within 5 seconds after powering the device back up.
This operation only resets the device to
the default factory settings.
To Unlock the lock