User's Manual

UG1000 Wireless Repeater
The UG1000R-A Wireless Repeater serves as a range extender. This device is able to join an above ground multihop
mesh network which then allows signals from underground sensors to travel above ground and reach controllers
(UG1000C-A), other repeaters and Bridges (UG1000B or UG1000B-A).
The UG1000R-A is typically installed outdoors and is wall mounted. The Repeater is powered using a wall wart that is
supplied with the unit. The external power supply is connected to the repeater per the following diagram.
Figure 1 Wirirng Diagram for the Repeater
A repeater after powering up joins an existing above ground Unet. This implies a controller or bridge must already be
present in the network for the repeater to be able to join the network.
+
-