MSDS

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: GLAZOL GLAZING COMPOUND / PAINTERS PUTTY HMIS CODES: H F R P
PRODUCT CODE: 155 1 1 0
SECTION 1 – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: [phone]
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: [phone]
NAME OF PREPARER: R. BARAKO
DATE REVISED: APRIL 2013
SUPERSEDES: JUNE 2011
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT
POLYMERIZED SOYBEAN OIL 68122-64-5 NOT ESTAB NOT ESTAB NOT ESTAB N/A 6
SOYBEAN OIL 8001-22-7 5 MG/M
3
NOT ESTAB NOT ESTAB N/A 4
POLYBUTENE 9003-29-6 NOT ESTAB NOT ESTAB NOT ESTAB N/A 3
STODDARD SOLVENT 8052-41-3 100 PPM 100 PPM 100 PPM 3.0 (68F) 1
GROUND LIMESTONE 1317-65-3 15 MG/M
3
10 MG/M
3
NOT ESTAB N/A 85
QUATERNARY AMMONIUM
MONTMORILLONITE 68953-58-2 NOT ESTAB NOT ESTAB NOT ESTAB N/A 1
No toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372 are present.
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: 308 –396F SPECIFIC GRAVITY (H20 =1) 2.1
VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER
COATING VOC: 0.26 LB/GAL (32 G/L)
SOLUBILITY IN WATER: INSOLUBLE
APPEARANCE AND ODOR: WHITE TO TAN PASTE
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: 104F METHOD USED: SETA CC
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: 0.1% UPPER: 7.0%
EXTINGUISHING MEDIA: FOAM, ALCOHOL FOAM, CO2, DRY CHEMICAL, WATER FOG
SPECIAL FIRE FIGHTING PROCEDURES: WATER SPRAY MAY BE INEFFECTIVE. IF WATER IS USED, FOG NOZZLES ARE PREFERRED. WATER
MAY BE USED TO COOL CLOSED CONTAINERS TO PREVENT PRESSURE BUILD UP AND POSSIBLE AUTO IGNITION OR EXPLOSION WHEN
EXPOSED TO EXTREME HEAT.
UNUSUAL FIRE AND EXPLOSION HAZARDS: KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE FROM HEAT, SPARKS, ELECTRICAL EQUIPMENT
AND OPEN FLAMES. CLOSED CONTAINERS MAY EXPLODE WHEN EXPOSED TO EXTREME HEAT.
SECTION V – REACTIVITY DATA
STABILITY: PRODUCT IS STABLE
CONDITIONS TO AVOID: HEAT, SPARKS, OPEN FLAMES, HIGH TEMPERATURES.
INCOMPATIBILITY (MATERIALS TO AVOID): STRONG OXIDIZING MATERIALS.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: FUMES, SMOKE, CARBON DIOXIDE, CARBON MONOXIDE, ALDEHYDES AND OTHER
DECOMPOSITION BY PRODUCTS IN CAS OF INCOMPLETE COMBUSTION.
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR