MSDS

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: DRYLOK LATEX BONDING AGENT HMIS CODES: H F R P
PRODUCT CODE: 130 1 0 0
SECTION 1 – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: [phone]
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: [phone]
NAME OF PREPARER: R. BARAKO
DATE REVISED: APRIL 2013
SUPERSEDES: APRIL 2010
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg@TEMP PERCENT
ACRYLIC POLYMER NOT ESTAB NOT ESTAB NOT ESTAB NOT ESTAB N/A 25
WATER 7732-18-5 NOT ESTAB NOT ESTAB NOT ESTAB 1.0 (68F) 75
No toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372 are present.
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: 212 (F) SPECIFIC GRAVITY (H20 =1) 1.0
VAPOR DENSITY: HEAVIER THAN AIR EVAPORATION RATE: SLOWER THAN ETHER
COATING VOC: N/A
SOLUBILITY IN WATER: SOLUBLE
APPEARANCE AND ODOR: WHITE TO MILKY, TYPICAL AMINE ODOR
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: N/A METHOD USED: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: 0.6% UPPER: 12.5%
EXTINGUISHING MEDIA: NONE KNOWN
SPECIAL FIRE FIGHTING PROCEDURES: CONTAINER MAY SWELL AND BURST DURING A FIRE DUE TO INTERNAL PRESSURE CAUSED BY
HEAT. THIS MAY CAUSE A SLIPPERY CONDITION ON FLOORS
UNUSUAL FIRE AND EXPLOSION HAZARDS: N/A
SECTION V – REACTIVITY DATA
STABILITY: PRODUCT IS STABLE
CONDITIONS TO AVOID: TEMPERATURES BELOW 32 (F) FOR STORAGE. TEMPERATURES BELOW 50 (F) FOR APPLICATION
INCOMPATIBILITY (MATERIALS TO AVOID): N/A
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: N/A
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR