MSDS

MATERIAL SAFETY DATA SHEET
PRODUCT NAME : DRYLOK ETCH HMIS CODES: H F R P
PRODUCT CODE: 120 1 0 1
SECTION 1 – MANUFACTURER IDENTIFICATON
MANUFACTURE’S NAME: UNITED GILSONITE LABORATORIES EMERGENCY PHONE: [phone]
ADDRESS: 1396 JEFFERSON AVENUE
SCRANTON, PA 18509 INFORMATION PHONE: [phone]
NAME OF PREPARER: R. BARAKO
DATE REVISED: APRIL 2013
SUPERSEDES: APRIL 2010
SECTION II – HAZARDOUS INGREDIENTS/SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS VAPOR PRESSURE WEIGHT
HAZARDOUS COMPONENTS CAS NUMBER OSHA PEL ACGIH TLV OTHER mmHg @TEMP PERCENT
SULFAMIC ACID 5329-14-6 NOT ESTAB NOT ESTAB NOT ESTAB N/A 100
EXPOSURE LIMITS FOR SULFAMIC ACID HAVE NOT BEEN ESTABLISHED BY OSHA OR ACGIH. AN 8 HOUR TIME WEIGHTED AVERAGE OF
1MG/M
3
IN AIR IS RECOMMENDED.
No toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and of 40 CFR 372 are present.
SECTION III – PHYSICAL/CHEMCIAL CHARACTERISTICS
BOILING RANGE: DECOMPOSES AT 401F (205C) SPECIFIC GRAVITY (H20 =1) 2.126
VAPOR DENSITY: NOT VOLATILE EVAPORATION RATE: NOT VOLATILE
COATING VOC: N/A
SOLUBILITY IN WATER: SOLUBLE
APPEARANCE AND ODOR: WHITE CRYSTALLINE SOLID. NO ODOR
SECTION IV – FIRE AND EXPLOSION HAZARD DATA
FLASHPOINT: WILL NOT BURN METHOD USED: N/A
FLAMMABLE LIMITS IN AIR BY VOLUME: LOWER: N/A UPPER: N/A
EXTINGUISHING MEDIA: WATER, CHEMICAL FOAM OR CARBON DIOXIDE (CO2) MAY BE USED FOR FIRES IN THE AREA.
SPECIAL FIRE FIGHTING PROCEDURES: N/A
UNUSUAL FIRE AND EXPLOSION HAZARDS: MAY RELEASE SULFUR DIOXIDE (SO2), SULFUR TRIOXIDE (SO3) AND AMMONIA GAS (NH3) IF
INVOLVED IN A FIRE.
SECTION V – REACTIVITY DATA
STABILITY: SULFAMIC ACID AND IT’S AQUEOUS SOLUTION ARE STABLE AT ROOM TEMPERATURE.
CONDITIONS TO AVOID: N/A
INCOMPATIBILITY (MATERIALS TO AVOID): A HAZARDOUS REACTION IN AQUEOUS SOLUTION MAY OCCUR WITH CHLORINE,
HYPOCHLOROUS ACID, HYPOCHLORITES, CYANIDES, NITRIC ACID OR SULFIDES.
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: SULFUR DIOXIDE (SO2), SULFUR TRIOXIDE (SO3), AMMONIA GAS (NH3).
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR