Owner Manual

Note: Press Cancel button to cancel all time settings. The settings will recede unless you press (Clock,
Timer On, Sleep ve Timer Off) necessary button to save your time settings in 20 seconds.
Press Cancel button to cancel all kinds of time settings. Repeated presses on the buttons will gear the
speed of buttons and intervals with the presses will slow down the process. Press Cancel button with
the intervals of 3 seconds to cancel all settings of your remote control. Set your Sleep timer again in
case of turning off and on the heater. Once you set your On/Off time, such functions will operate in daily
set times. The heater is to be in stand-by mode to operate On timer. Clock and UFO logo keeps
functioning in stand by mode.
Control through the main module on the heater:
HO indicator appears on the screen when the heater is switched on and it is in stand by mode. The
1st digit on the screen illustrates H symbol while 2nd digit illustrates power level mode from 1 to 5.
The button number 1 on the heater functions as ON / OFF. The heater starts operating at the power
level mode at which it has been switched off.
Press the button number 2 on the heater to adjust power mode. Tilt indicator starts functioning and
"2 " 3 indicator appears on the screen warning through a buzzer voice when the heater operates in a
slope larger than 5°. The heater starts operating in stand by mode (HO) when it has been adjusted in
the right position.
HO appears on the screen when pressed ON / OFF button and the power level mode (H1, H2, H3, H4
and H5) is adjusted through the buttons on the remote control. Press ON / OFF button on the remote
control or the heater itself to switch off the heater. The heater starts functioning in stand by mode after
electricity cut. LED keeps flashing in case of a program set by remote control. Buzzer signal is given
following each command.
The LED panel on the body of the UK heater allows you to turn the unit ON or OFF and set the power
level. No programmed or timer operations can be initiated from the LED panel.
Pressing the ON/OFF button with the heater in standby mode will power the heater on at the last-used
power setting. Pressing the MODE button changes the power setting. The LED will display that setting
(HO, H1, H2, H3, H4, etc.). If a programmed operation has been entered via the remote control
(above), the normal power display (HO, H1, etc.) will blink intermittently.
NOTE: If the heater is tilted, the LED will blink "Er" and the unit will beep until it is returned to the
horizontal position.