Owner Manual

Power the unit on by pressing the ON/OFF button.
When the power is initially turned on, the UP/DOWN arrows control the power setting of the heater.
Adjust the heater to the desired power level before continuing with the timer settings. When you press
the CLOCK button, the UP/DOWN arrows are used to set the clock.
Pressing the arrows repeatedly accelerates or slows down the change interval. Pressing the TIMER
ON button lets you use the UP/DOWN arrows to designate a time when you want your heater to come
on. Pressing the TIMER ON button again saves that setting. Pressing the TIMER OFF button lets you
use the UP/DOWN arrows to set the time when you want your heater to turn off.
Pressing the TIMER OFF button again saves that setting. Once the TIMER ON and TIMER OFF
settings have been entered, you can press the EVERYDAY button to repeat the on and off times on a
daily basis. Unless cancelled or otherwise modified, the TIMER ON and TIMER OFF settings you
enter will be repeated every day. The unit must be in STANDBY mode (plugged in) for timer operations
to occur. The LED screen on the heater body will flash continuously when any program is set via the
remote control. Pressing the SLEEP button allows you to operate the heater for a designated amount
of time before shutting off.
Using the SLEEP function will override current TIMER ON/OFF programmed settings, but will not
cancel future programmed operations. Pressing the CANCEL button clears each program entry. Wait
three seconds between presses to go back through your times.
The screen of the remote control starts
functioning after inserting the batteries. UFO
logo and flashing clock indicator starts
appearing on the screen.
Power mode indicator (model) starts
functioning after pressing On / Off button.
Operation of the Remote Control
Inserting Batteries
Insert 2 AAA/ Alkaline type batteries into your Remote Control.
1- Flip the backside of your remote control and pull out battery
cover. Insert the batteries in accordance with the instructions and
polarity of the batteries.
2- Change the batteries in the same way depicted above.
NOTICE:
1- Replace the old batteries with the same type batteries.
Otherwise, your heater may not function well.
2- Pull out the batteries in case of long terms of disuse to prevent
leakage which may impair your remote control.