User guide

Compact DMX Illuminator Range

INSTALLATION GUIDE (Continued)

OPERATION (Continued)

When the DMX illuminator is powered up the unit will RESET during which, the

following flashing message will be displayed on the front panel display

(Item 4 Page 1):

When the illuminator is RESET the following message will be displayed:

This indicates the illuminator has been set to address 001 by default.

PROGRAMMING

At any stage during programming, when changes are made the DMX may go

through the RESET phase as described above – this is normal.

Changing Address

To change the address press the 2 buttons to the le of the display (Items 2 & 3 Page

1) simultaneously once the small indicator in the bottom right of the display will go

out. Scroll for the required address as follows:

Once the selected address is found, there will be a short delay (may RESET) until the

small indicator illuminates confirming the address is set.