Quick Start Guide

39
uArm Community
UFACTORY Official Forum
uArm User Facebook Group
uArm Technical Support
Release Note
Version
Note
1.0.7
Modify several steps of 3D printing and fix the misunderstanding
Add the laser mode command G1
Tony
1.0.8
Add more details about OpenMV
Add the note of laser focusing
Add the caution of installing base extension
Add the caution of user defined button
Tony
1.0.9
Modify the steps of laser focusing and grove installing
Tony
1.0.10
Add more details to OpenMV tutorial
Add details to offline learning modess
Add M2500 command in command list
Tony
1.0.11
Modify the OpenMV instructions
Add more Gcode commands
Tony
1.0.12
Add the details of installing the tube in 3D printing mode
Tony
1.0.13
Add new picture of working range
Tony
1.0.14
Add cautions in 3D printing
Tony
1.0.15
Modify several commands of Gcode
Redesign the layout of this guide
David
ChengHan