Owner's manual

TEMPERATURE CALIBRATION
Aprocesstosettemperaturecalibrationtoanice
pointisincludedtocompensatefordifferencesin
temperaturesensors,ortoresettheunittoproper
operation.Pleasefollowthesestepstoperforma
temperatureset;
 1. Connecttemperatureprobe
 2. Press“PressureTEMP”todisplayprobe 
  temperature(verifythat“TEMP”isshownon 
  theLCD.
 3. Placethetemperatureprobesensingareaina 
  mixtureofcrushediceandwater.(Distilled 
  waterwillprovidethemostaccuratesource)
 4. Stirtheicewatermixturewiththetemperature 
  probeandallowthereadingtostabilize
 5. Pressandhold“TempSH/SC”buttonforfour 
  seconds
 Thiswillsettheicepointto32°F.Themeterwill 
 compensateforchangesupto10°F.
9.