User Manual

BatterieS rePlaCemeNt

This meter has been designed for use with alkaline

batteries. No other types are recommended. The analyzer

is supplied with 4 “AA” size alkaline batteries.

These should be installed into the instrument as shown

in the diagram to the right and indicated on the back of

the unit.

CAUTION!

Take great care when installing the batteries to observe

correct polarity. Always check the meter for operation

immediately after installing new batteries.

eleCtromagNetiC ComPatiBility (emC)

This product has been tested for compliance with the

following generic standards:

 EN50081-1,EN50082-1andiscertifiedtobe

compliant.

 TheEuropeanCouncilDirective89/336/EECrequiresthatelectronicequipmentdoesnotgenerate

 electromagneticdisturbancesthatexceeddefinedlevelsandhasanadequatelevelofimmunitytoenableitto

be operated as intended.

 Sincetherearemanyelectricalproductsinusethatpre-datethisDirectiveandmayemitelectromagnetic

 radiationinexcessofthestandardsdefinedintheDirectivetheremaybeoccasionswhereitwouldbe

appropriate to check the analyzer prior to use. The following procedure should be adopted.

  •Gothroughthenormalstartupsequenceinthelocationwheretheequipmentistobeused

 •Switchonalllocalizedelectricalequipmentthatmightbecapableofcausinginterference

  •Checkthatallreadingsareasexpected(alevelofdisturbanceinthereadingsisacceptable)

 •Ifnot,adjustthepositionoftheinstrumenttominimizeinterferenceorswitchoff,ifpossible,the

  offendingequipmentforthedurationofthetest

 Atthetimeofwritingthismanual(July2008)UEiisnotawareofanyfieldbasedsituationwheresuch 

 interferencehaseveroccurredandthisadviceisonlygiventosatisfytherequirementsoftheDirective.

Note: Follow battery directions

on back of housing

Battery Compartment

Cover

Back of

Instrument