INSTRUCTION MANUAL 1-800-547-5740 • Fax: (503) 643-6322 www.ueitest.com • email: info@ueitest.
Introduction The PET1 is a convenient pocket-size multifunction tester, which combines the latest digital technology with an advanced sensor to detect high/low AC voltage. Non-Contact AC Voltage Testing Press the switch to test. To locate "LIVE/HOT" side of a wire, lower sensitivity until the detector only sounds on one wire.
Ground/Earthing check Move the tester close to a plugged-in (not turned on appliance). The buzzer comes ON if the "GROUND/EARTHING" is not connected at the outlet. GOOD LED blinks and buzzer sounds FAULT No response NOTE: 1. To Reduce Sensitivity If sensitivity is too high, rotate adjustment left (counter-clockwise) Flashlight LED (1) lights up when switch is pressed 2. Static electricity may be generated by rubbing the plastic housing thus causing an indication (LED blinks). 3.
Buzzer Twist to open battery compartment Battery compartment (cover) Clip Inside of battery compartment Insert batteries (+) up and (-) down Press switch (Press: ON) (Release: OFF) Adjustment knob LED Power on when green. Flashing increases with intensity Flash Light, super bright white LED (1) Test Pin (Fig 1) PET1-MAN P.
PET1 Pocket Electrical Tester Limited Warranty The PET1 is warranted to be free from defects in materials and workmanship for a period of three years from the date of purchase. If within the warra n ty period your instrument should become inoperative from such defects, the unit will be repaired or replaced at UEi’s option.
